Suzhou Electric Appliance Research Institute
期刊号: CN32-1800/TM| ISSN1007-3175

Article retrieval

文章检索

首页 >> 文章检索 >> 往年索引

发电机手包绝缘表面电位测试接线原理及改进

来源:电工电气发布时间:2019-02-19 09:19 浏览次数:621
发电机手包绝缘表面电位测试接线原理及改进
 
张树铭
(中国大唐集团科学技术研究院有限公司华东电力试验研究院,安徽 合肥 230088)
 
    摘 要:介绍了发电机定子绕组手包绝缘施加直流电压测量方法,阐述了正接线和反接线试验方式的试验方法和实验原理,分析对比了两种接线方式的优缺点,针对传统的试验接线方式中存在的问题提出了改进措施,给出了一种新的基于传统反接线方式的手包绝缘测试方法,既能满足在定子通水状态下进行试验,又极大地缩小了试验设备容量,工程运用表现良好。
    关键词:手包绝缘;表面电位;反接线方式优化
    中图分类号:TM303.1;TM306     文献标识码:B     文章编号:1007-3175(2019)02-0056-04
 
Wiring Principle and Improvement of Surface Potential Test for Generator Hand-Making Insulation
 
ZHANG Shu-ming
(China Datang Corporation Science and Technology Research Institute Co., Ltd, East China Electric Power Test Research Insitute, Hefei 230088, China)
 
    Abstract: Introduction was made to the method of direct current voltage measuring imposing on the hand-making insulation of generator stator winding. This paper expounded the test method and experimental principle of positive and reverse connection test modes, and analyzed and compared two kinds of relative merits of two types of connection modes. Aiming at the problems existing in traditional test connection mode, this paper proposed the improved measures and gave a new kind of hand-making insulation test method, which not only met the requirements of the test under conditions of stator through-water state, but also greatly reduced the test facility capacity, with good engineering application.
    Key words: hand-making insulation; surface potential; reverse connection mode optimization
 
参考文献
[1] 芦竹茂,梁基重,王天正,等. 发电机手包绝缘表面电位试验的应用[J]. 大电机技术,2015(3):32-35.
[2] 薛敏,翟永祥. 水内冷发电机定子线棒端部手包绝缘的测试[J]. 安徽电力,2015,32(1):15-19.
[3] 徐强. 发电机手包绝缘故障电位外移试验方法浅析[J]. 黑龙江科技信息,2012(21):57-58.
[4] 吴影, 梅志刚. 定子端部手包绝缘表面电位测量的电路分析与试验要点[J]. 华北电力技术,2008(10):25-27.
[5] 任守强. 600 MW发电机定子线圈端部手包绝缘缺陷的测试及处理[J]. 黑龙江科技信息,2015(3):96.