330 kV变压器局部放电试验加压方式研究 

温定筠，孙亚明，吕景顺，张玉 
(国网甘肃省电力公司电力科学研究院，甘肃 兰州 730050) 
 

摘 要： 针对330 kV 变压器局放试验，分析了试验加压方式并通过工程验证得出变压器低压绕组额定电压较高时，采用对称加压方法，试验设备额定电压可以降低为单边加压方案的一半，有利于提高工作效率。对称加压法试验时，对变压器高、低压绕组之间绝缘及中、低压绕组之间绝缘考核更为严格，低压绕组端子耐受电压情况更接近运行实际，有利于提高缺陷检出率，保证设备的安全投运。
关键词： 变压器；局部放电试验；单边加压；对称加压
中图分类号：TM406 文献标识码：A 文章编号：1007-3175(2014)05-0023-03

Study on Pressurized Way of Partial Discharge Test for 330 kV Transformer 

WEN Ding-jun, SUN Ya-ming, LV Jing-shun, ZHANG Yu 
（Gansu Electric Power Research Institute, Lanzhou 730050, China） 
 

Abstract: For 330 kV transformer partial discharge test, this paper analyzed the pressurized way of tests. The engineering verified that when the rated voltage of transformers low-voltage winding was higher, the symmetrical pressurized method was adopted and the rated voltage of test equipment could be reduced to half of the unilateral pressurized scheme, in favor of the improvement of work efficiency. At the time of symmetrical pressurized test, the assessment of insulation between the high and the low voltage windings was more stringent, as well as the assessment of insulation between the medium and the low voltage windings. The withstand voltage of low voltage winding terminals ran closer to the actual situation, in favor of improving the defect detection rate and ensuring the safety operation of equipment.
        Key words: transformer; partial discharge test; unilateral pressure; symmetrical pressure

参考文献
[1] 胡启凡.变压器试验技术[M].北京：中国电力出版社，2010.
[2] 陈天翔，王寅仲，海世杰.电气试验[M].2版.北京：中国电力出版社，2008.
[3] 谢毓城.电力变压器手册[K].北京：机械工业出版社，2003.